Last updated: 10/25/2024 8:49 AM
THE BARGAIN ZONE
The following equipment package is for sale in the Rocky Mountains priced for a quick sale!
FRANKS EXPLORER WELL SERVICE RIG (Ref#13106R) Manufactured 1968, completely rebuilt 2011, workover rig, PTO, mounted on CCC with 6V71 Detroit engine, doghouse.
Also includes:
WHITE WESTERN HOT OIL TRUCK Built 1981. Mounted on tandem axle White Western truck powered by Cummins diesel. 75 barrel square stock tank. (2) 250 gallon propane tanks. Gardner Denver PE3 triplex pump. Bowie pump. Centrifugal 2x3x13 NCM Model 250X pump (near new buts needs installed). 7,000,000 BTU heater
120 BBL WATER TRAILER Built 1989
3-AXLE GOOSENECK TRAILER Was used for transporting doghouse
PACKAGE PRICE FOR QUICK SALE: $72,000
1982 GMC PUMP TRUCK (Ref#6313Tc)
Well service or cement plugging, BJ 1000 low drive pump, 10000psi with 8 bpm at 2000 psi Price: $32,000
1979 MACK SWAB RIG (Ref#2970Ta)
Needs to be mounted on newer truck Price: $26,500
80 PSI TREATER (Ref#2970Tc)
6 x 10 horizontal gas/oil separator Price: $26,500
MACK WINCH TRUCK (Ref#2970Te)
Live tail roll, used to pull tri axle trailer Price: $13,500
300 BBL SKID MOUNTED TANKS (Ref#2970Tf)
(2) 300 bbl tanks used for plugging, on skids Price: $6,900 each
SCHRAMM T64 DRILL RIG (Ref#7149Ta)
5 x 6 mud pump, air compressor is blown, 8V71 Detroit on deck, mounted on Chevy truck with 427 gas engine, 500’ of 4” x 20’ drill pipe, 6” hammer, 4” hammer Price: $37,500
WALKER-NEER 250-40 DRILL RIG (Ref#1744T)
Refurbished 2000, (2) Cat C15 diesel engines (one powers rig, one powers HPU), pipe handling arm, currently reworking tophead Price: $170,000
MUD ROTARY RIG (similar to Mayhew) (Ref#9761T)
Built 1950’s, 5” table, 3 x 6 Wheatley 2-piston mud pump (with 2 new spare liners and 2 new spare pistons), approx. 15’ kelly, mechanical rig, well maintained, mounted on 1999 International 4700 w/DT 466E 6 cylinder engine, PTO, runs 10’ drill rod Price: $31,500
PLAIN STATES MFG A30 DRILLING RIG (SIMILAR TO GUS PECH) (Ref#8886T)
Built 1990, good for small spaces, 80 cfm hydraulic air compressor, 4 x 2 centrifugal mud pump, 2 winch cables, mounted on single axle 1990 International 4x2 truck with diesel engine, PTO, mud pump, stabilizer, rod box, mud pan, surface tube, approximately 200’ of 5’ rods, 8-3/4” bit, 10’ stabilizer, breakaway hydraulic wrench, 2 rear hydraulic leveling jacks, motor rebuilt 2022 and has drilled 5 wells since Price: $37,500
DEEPROCK 155 DRILL RIG (Ref#9723T)
Manufactured 2007, 4x3 Mission Magnum mud pump, no air, uses 15’ drill pipe, slide out tophead that makes capable of setting 20’ casing with 4’ clearance from the ground, mounted on Ford 650 single axle truck with Cummins diesel PTO engine, Otto rod handling system, jib boom, tophead, 4 leveling jacks, comes with 300’ of 15’ x 2-3/8 Mayhew Jr drill pipe, brand new 4x8 aluminum mud pan
Unit was overhauled in 2023 including drain/fill transmission with 50wt synthetic, gearbox drain/fill with 50wt synthetic, all hydraulic filters changed, rebuilt otto rod loader (new bearings, clamps and wear bolts), Tophead disassembled and installed new bearings and seals/add fluid plug sight and drain plug/refill with 80-90 gear lube, mud swivel rebuilt, rebuilt autobreakout system, replaced all mud piping with welded SCH 80 and stainless steel ball valves, install 4x3 mission mud pump and hydraulic motor, rebuilt mast lock, all new headslide machine bolts, many hoses replaced, 4 stabilizer jacks resealed Price: $170,000
SPEEDSTAR SS15-III DRILL RIG (Ref#9337T)
Manufactured 1977, LeRoi 256-S2 450/250 air compressor, 4 x 4 x 13 centrifugal pump (he uses for drilling), mounted on 1977 GMC 9500 truck with 290 Cummins engine, PTO, rod box, leveling jacks, no carousel, 300’ of 3-1/2” x 20’ flush wall drill pipe, good shape, running rig, handling tools, bits Price: $60,000
GEOSPACE 750 (Ref#13745T)
Developmental air compressor, heavy duty winch on front, 391 PTO gas engine in truck, Mounted on 1971 Ford truck, 2 rear hyd jacks, in Nov 2023 they started up the rig and replaced all the hydraulic hoses Price: $19,500
PORTADRILL TLS DRILL RIG (Ref#152Ta)
Manufactured 1981, 900/350 Sullair compressor, Detroit 12V71TT diesel engine, mounted on Ford 9000 truck, new rotation pump and motor, 80% rebuilt top head, 3 cyl GMC water pump, deep hole derrick, drawworks, sliding table, 5 leveling jacks, swing out powerhead, 8” EDM hammer, 6” Searock hammer, 200’ drill pipe, tools Price: $80,000
Video links:
https://youtu.be/sIS7Oq-YLok
https://youtu.be/UwQqnywkyTo
https://youtu.be/h9es8XaE2-8
https://youtu.be/-2EG4tMhGvw
https://youtu.be/Uj_d786OHQo
https://youtu.be/ShzbPKUjcbY
https://youtu.be/2aUcT5tfE04
WAGNER MOREHOUSE WELL SERVICE RIG (Ref#7837T)
350 GM deck engine, mounted on 1986 GMCtruck, 454 GM engine, sandline, approx 50' pole, no cathead, can pull single, ready to work, tooled PRICE: $19,500
REVERSE OSMOSIS WATER FILTRATION/PURIFICATION UNITS (Ref#10839T)
Two available, reverse osmosis system Price: $29,500 each
SHOP BUILT MUD ROTARY RIG (Ref#4668T)
Built 1986, approx 420’ depth capacity, double drum drawworks (shop build with triple clutch on each side), Gardner Denver 5 x 8 mud pump, 2” DSM swivel, 8-1/2” retractable table, trailer mounted, 46’ mast mechanically raised, 4” x 32’ square kelly, 420’ of 2-7/8” drill pipe Price: $39,500
INGERSOLL RAND DM25SP (Ref#9817R)
Track drill with Cummins KT1150 engine, recently rebuilt, 750/300 air compressor, hot box, dust box, new 2 7/8” x 48’ kelly PRICE: $50,000
BOWEN 2.5 POWER SWIVEL (Ref#3694T)
85 ton, used, Cummins 4 cylinder turbo diesel engine, hydraulic controls, pumps, motors, filtration system. EVCO wire cable control panel, hydraulic driven reels, new 150’ hose per reel, mounted on 2 axle trailer, new bearings, wash pipe, etc. Located Europe. Price: $52,500 USD
KING 3PS POWER SWIVEL AND HYDRAULIC POWER UNIT (Ref#7913Tb)
85 ton, 45 gpm @ 3000 psi max working pressure, Cummins diesel engine, extra set of packing Price: $42,500
(3) INGERSOLL RAND TRUCM DRILL RIGS PACKAGE (Ref#2100T)
INGERSOLL RANDTRUCM Manufactured 1975, 750/250 air compressor, 903 Cummins diesel on deck, mounted on Crane Carrier with 501 gas engine, water injection pump, 240’ of 4-1/2” x 25’ drill pipe, handling tools, running condition
INGERSOLL RAND TRUCM Manufactured 1974, 750/250 air compressor, 903 Cummins diesel on deck, mounted on Crane Carrier with 501 gas engine, water injection pump, 240’ of 4-1/2” x 25’ drill pipe, handling tools, running condition
INGERSOLL RAND TRUCM Mounted on Crane Carrier with 501 gas engine, 903 Cummins diesel engine, parts rig
PRICE FOR ALL THREE RIGS: $60,000
FAILING 1500 (Ref#7758T) 8” retractable table, Ford gas deck engine, mounted on 10 wheeler with gas engine, 3 hyd leveling jacks, no rod box or pipe rack, incluees 390’ of FEDP pipe, 14” bit Price: $19,500
CME 750 AUGER DRILL AND TRUCK/TRAILER PACKAGE (Ref#5897T)
Manufactured 1972, Moyno pump, mounted on ATV buggy carrier powered by Ford 300 6-cyl gas engine, PTO, CME auto hammer, cathead, in/out slide base, 3 leveling jacks, auger racks, large tool box, water tank, 3 winches, quick disconnect tower. 2001 Freightliner FL70 with diesel engine and 31’ Roge trailer. Package Price: $50,000
BOWEN 2.5 POWER SWIVEL (Ref#12755Tb)
Trailer mounted Price: $27,500
VACUUM UNIT (Ref#3239T)
(2) Motor Model PM70T vacuum pumps 1100 rpm, 247 cfm, max vacuum 28 hg (in) max pressure 21.7 psig, (2) Brook Crompton Model EEx d Flame Proof Motors Zone 1 Suitable, 380-415V 3-phase, 50/60 Hz, 11-15 kW 1450-1750rpm, 2000 liter vacuum tank, explosion proof electrical control panel, 60 meter suction and discharge hose, primary and secondary cut off, safety filter, oil silencers, pressure relief valves, vacuum relief valves, pressure vacuum gauge, sight glass levels, located Southeast Asia Price: $42,500
BOWEN 2.5 POWER SWIVEL (Ref#4682T)
Manufactured 2007, skid mounted, Cummins diesel engine, hydraulichose reel, operators console, located Texas Price: $24,500
1989 MACK MIDLINER CABOVER WATER/SERVICE TRUCK (Ref#10449Rb)
Diesel engine, 22’ steel flatbed, 33,000# GVW, air brakes, 6 speed transmission, 225 gallon water tank Price: $7,500
COIL TUBING UNIT ON KENWORTH TRIPLE AXLE TRAILER WITH SLEEPER CAB (REF#59T)
Built 2007. 5,700 hours. Evenflow Model FCT4500 coil unit. Capacity: 3/4" to 2 7/8" diameter tubing, maximum speed 200' per minute, pull force 80,000lbs. Common usage well service industry. Mounted on Kenworth T800 Tridem 8x4 trailer and tractor with 86" extended sleeper, equipped with 4 hydraulic outriggers. Powered by CAT C15 diesel engine, rated 550 HP. Fabco box to power injector reel and auxiliary circuits. Coil reel 162,000lb capacity, coil is hydraulically powered with level-wind apparatus. Coil diameter: 108" with outside diameter 137", 10,000 PSI working pressure, No BOP or stripper. Dimensions and weight: 43'L x 105,000lbs. Used lightly and intermittently. Located Texas. Price: $180,000
Financing Available* No money down
* 5-year terms available
* 1-page application to qualify
* No financials required
* Standard requirements: 2 years in business, solid personal credit.
CLICK HERE FOR ONE PAGE CREDIT APP